Great Plains 3P806NT Operator Manual - Manual (Page 18)

14 3P806NT Table of Contents Index Great Plains Manufacturing, Inc.
151-143M Table of Contents Index 2011-12-20
Hitching Tractor to Drill
The 3P806NT is a 3-Point Category II hitch implement,
employed in 2-point Semi-Mounted mode.
Note: The top link of the tractor 3-point is not used for
transport or field operation. Full 3-point mode is
incompatible with lift-assist.
1. Remove tractor drawbar before hitching. The drill
gauge wheel tire or assembly will be damaged if it
contacts the drawbar during hitching, raising or
lowering operations.
2. If a hitch extension is required, install the extension
or setback on the drill, per the instructions at “Hitch
Extension Installation” on page 89, before
continuing with hitching.
Equipment Damage Risk:
Great Plains CPH, PFH or SSH accessory hitches are not
compatible with the 3P806NT.
Crushing Hazard:
You may be severely injured or killed by being crushed
between the tractor and drill. Do not stand or place any part of
your body between drill and moving tractor. Stop tractor
engine and set park brake before installing hitch pins.
3. Raise or lower tractor 3-point lift arms, or hitch
extension, as needed and pin lower arms to drill.
Upper arm is unused.
4. Set your tractor 3-point draft control to Float position.
Equipment Damage Risk:
Do not raise tractor 3-point lift arms until after hydraulic and
electrical connection have been made.