Great Plains 3P806NT Operator Manual - Manual (Page 9)

Great Plains Manufacturing, Inc. Table of Contents Index Important Safety Information 5
2011-12-20 Table of Contents Index 151-143M
Safety Decals
Safety Reflectors and Decals
Your implement comes equipped with all lights, safety
reflectors and decals in place. They were designed to
help you safely operate your implement.
▲ Read and follow decal directions.
▲ Keep lights in operating condition.
▲ Keep all safety decals clean and legible.
▲ Replace all damaged or missing decals. Order new decals
from your Great Plains dealer. Refer to this section for
proper decal placement.
▲ When ordering new parts or components, also request
corresponding safety decals.
To install new decals:
1. Clean the area on which the decal is to be placed.
2. Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
Reflector: Slow Moving Vehicle (SMV)
On top of lift assist pivot weldment;
1 total
See “Transporting” on page 25.
Reflectors: Red
On rear face of lift assist cross tube, outside daytime
reflectors;
2 total
See “Transporting” on page 25.
Reflectors: Amber
On side frames at walkboard ends,
on front face of lower front tool bars, outside ends;
4 total
See “Transporting” on page 25.
818-055C
32546
838-266C 32546
838-266C
32546