Great Plains 8560 FCF Assembly Manual - Manual (Page 16)

12 8323-8560FCC Great Plains Manufacturing, Inc.
560-483Q-ENG 02/10/2014
Install 8332 & 8336 Wings
Refer to Figure 11
Note: Be sure and install the 1 x 6 1/4 hinge pins
as
shown with roll pin in slot on front side of hinge.
48. Carefully align holes in wing frame LH with holes in
center frame. Secure with 1 1/4 x 6 1/4 hinge pins ,
3/8 x 2 1/2 roll pins, 1 flat washer 1 top lock nut.
49. Attach wing brace to the front of the wing frame LH
with 3/4 x 2 hex bolts , 3/4 lock washers and 3/4
hex nuts.
50. Align holes in wheel arm L , secure with 1 1/4 x 6
pins , 3/8 x 2 1/4 hex bolts and 3/8 top lock nuts.
51. Fasten LH wing truss to wing with 5/8 x 1 1/2 hex
bolts , 5/8 lock washers and 5/8 hex nuts.
52. Mount wing extension to outside of wing and wing
brace with 5/8 x 1 1/2 hex bolts , 5/8 lock washers
and 5/8 hex nuts.
53. Mount wing fold bracket to wing with 3/4 x 5 hex
bolts , 3/4 lock washers and 3/4 hex nuts, 5/8 x 3
1/32 x 5 1/2 u-bolts , 5/8 lock washers and 5/8 hex
nuts.
54. Attach base end of 3.25 x 8 x 1.25 lift cylinder to
front hole of cylinder mount plate with 1 x 3 1/8 pin
, 1.5 x 1.0 x.075 machine washer and 3/16 x 2 cot-
ter pin. Attach rod end of 3.25 x 8 x 1.25 cylinder
to wheel arm L
with 1 x 3 1/8 pin , 1.5 x 1.0
x.075 machine washer and 3/16 x 2 cotter pin.
55. Attach base end of 4 x 30 x 1.5 fold cylinder to
hole of center fold bracket with 1 x 3 1/8 pin , 1.5 x
1.0 x.075 machine washer and 3/16 x 2 cotter pin.
56. Attach 5” stub to outside of wing extension , with
5/8 x 1 1/2 hex bolts , 5/8 lock washers and 5/8 hex
nuts.
57. Do not attach rod end of fold cylinders until fold sys-
tem has been purged, See “Purging Hydraulic Sys-
tem” on page 22
58. Repeat same procedure for right wing.
59. Tighten all bolts to specs, See “Torque Values
Chart” on page 25.
Figure 11
8332 & 8336 Wing Assembly
41893
1
4
15
3
U
D
F
B
L
R
14
8
2
13
16
5
15
11
8
2
8
7
17
9
12
10
6
2
1
2
3
1 4
5
6
7
8
9
8
10
11
12
13
14
15
13
5 15
16
15
17 9
8