Great Plains 8560 FCF Assembly Manual - Manual (Page 23)

Great Plains Manufacturing, Inc. Assembly 19
02/10/2014 560-483Q-ENG
Install 3-Section Double Tee Block
Refer to Figure 23
119.Thread elbow (adjustable stud) fitting
into rear ports
of double tee block . Thread straight (non- adjustable
stud) fittings into left and right ports of double tee
block .
Note: Tighten ORB fittings, See “Install Rebound Valve and
O-Ring Fittings” on page 18.
Install 5-Section Double Tee Block
Refer to Figure 24
120.Thread elbow (adjustable stud) fitting
into rear and
front ports of double tee blocks . Thread straight (non-
adjustable stud) fittings into left and right ports of dou-
ble tee block .
121.Fasten MJIC tee’s between hoses as shown.
Note: See “Install JIC Fittings” on page 20 for proper instal-
lition.
Note: Tighten ORB fittings, See “Install Rebound Valve and
O-Ring Fittings” on page 18
Install Hose Handles
Refer to Figure 25
Note: Hose handles are color coded. See “Hydraulic Hose
Hookup” on page 21 for proper placement on hoses.
122.Install fittings to end of hoses running to front of
hitch. Attach poppet fittings to fittings .
123.Tighten ORB fittings, See “Install Rebound Valve and
O-Ring Fittings” on page 18
124.Align the grooves in the front of the hose handles to
the back two ribs of fittings as shown and install the
self threading screws through holes.
125.Route hoses as shown in layout section in “Operator’s
Manual”.
Figure 23
3-Section Double Tee Block
41915
U
D
F
B
L
R
2
1
3
2
1
3
1
Figure 24
5-Section Double Tee Block
41916
U
D
F
B
L
R
1
2
4
3
2
1
3
1
4
Figure 25
Hose Handle Assembly
41672
U
D
F
B
L
R
3
1
2
5
4
2 1
3 2
4
2
5