Great Plains 3P1006NT Assembly Instructions - Manual (Page 11)

Install Hydraulics Front Page Part Lists Great Plains Manufacturing, Inc. 11
05/05/2011 Front Page Part Lists 151-181M
Install Hydraulics
Install Hydraulic Cylinder
Refer to Figure 14
42. Select one each:
810-316C CYL 3.5X12X1.25 ROD (TIE RO
161-107H NTA35 WING EYEBOLT WELDMENT
804-030C WASHER LOCK 1 1/4 SPRING PL
805-159C PIN CLEVIS 1 X 3 1/8 GR5 PL
803-034C NUT HEX 1 1/4-7 PLT
890-005C BUSHING CYL 1 1/4 X 1 X 1
805-104C PIN COTTER 3/16 X 1 1/2 PLT
Thread one nut on eyebolt before placing on
the inside and up through top of the bolt on mount
. Secure exposed eyebolt on top of mount with
washer and second nut .
Place bushing (not shown) through eye of eyebolt
then center hydraulic cylinder over eye of eyebolt
and insert pin clevis through one side slot on
mount, secure on other side with flat washer and
cotter pin .
43. Select one each:
805-159C PIN CLEVIS 1 X 3 1/8 GR5 PL
804-029C WASHER FLAT 1 SAE
805-104C PIN COTTER 3/16 X 1 1/2 PLT
811-722C BREATHER PLUG 9/16-18 MORB
Secure bottom of cylinder to lift assist (on lower par-
allel arm at cylinder lug) using pin clevis
, flat
washer and cotter pin .
Breather plug should already be installed in rod end
of cylinder.
44. Put remote outlet in float to remove hydraulic pres-
sure.
Eyebolt Adjustment
45. To start with, adjust eyebolt length to 3.5 inches.
46. Loosen the jam nut
47. Rotate the adjuster nut (under weldment top, not
visible in figure) by amount of change required.
Check eyebolt
length.
48. Tighten the jam nut.
Figure 14
Hydraulic Cylinder
32151
35
21
42
43
38
38
35
44
53
13
39
44
21
39
43
35
53
42
35 21
13
39 35
53
21
43
38
42
43
38
42
47
43
38 42
4
1
3
3.5in (88.9mm)
4
1
3
4