Great Plains 2020P Operator Manual - Manual (Page 35)

4/23/2010 118-740M
33 Adjustments
Cleaning Out Meters
NOTE: Shut off sliding seed tubes before at-
tempting to clean out seed meters.
For seed meter clean out:
Refer to Figure 34
1. Position tarp or buckets under the opener(s)
whose meter(s) you will be cleaning out.
2. Remove retaining clip and pull pin.
Refer to Figure 35
3. Pull up on meter clean out door to open.
Refer to Figure 36
4. When meter is empty, push meter clean out
door back to its original position to close.
NOTE: You may need to shake the clean out
door a little before closing to make sure all
seeds fall out.
5. Replace pin and retaining clip.
Figure 34
Meter clean out
18261
Retaining clip
Clean out door
Figure 35
Meter clean out door
19190
Clean out door
Figure 36
Close and pin clean out
19192
Clean out door