Great Plains 2020P Operator Manual - Manual (Page 37)

4/23/2010 118-740M
35 Adjustments
Refer to Figure 40
4. Pull seed meter wheel out about 1/4 inch, or
past the wheel drive pin, and spin backward to
clean out seeds from top pockets.
5. Remove seed meter wheel.
NOTE: With the seed meter wheel removed,
you may want to check the meter for internal
damage or trash.
Refer to Figure 41
6. Place new wheel on meter wheel shaft and
push meter slide retaining clip forward while
pushing in seed meter wheel.
Refer to Figure 42
7. Be sure slots in the center of seed meter
wheel are aligned with the wheel drive pin on
the meter shaft.
Figure 40
Remove seed meter wheel
18295
Spin wheel
backward before
removing
Wheel
drive pin
Retaining
clip
Figure 41
Place new seed meter wheel on wheel shaft
18296
Wheel
drive pin
Figure 42
Position seed meter wheel
18299