Great Plains CF600 Predelivery Manual - Manual (Page 10)

8
Section 1 Assembly
CF500 and CF600 Hydraulic Cross-Fold Boom 506-582Q 2/2/06
Great Plains Mfg., Inc.
12. Hydraulically fold boom, watching that boom wings
meet rubber stops (1) on top of center posts. Stop
boom folding and adjust brackets (2) in or out if neces-
sary. Refer to Figure 1-15.
Figure 1-15
Boom Wings Meet Stops
13. Refer to Figure 1-16. Connect each spring shackle (1)
to its cable (2) by removing bolt and replacing through
cable eye as shown.
Figure 1-16
Connect Cables and Spring Shackles
14. Connect boom-lock cable to clevis.
Figure 1-17
Boom-Lock Cable
17610
16914
17614
15. Unfold boom.
16. Refer to Figure 1-18. Adjust spring nut (1) so spring is
compressed to 10 1/4 inches. Lock with second nut
(2).
Figure 1-18
Spring Shackle Adjustment
17. Refer to Figure 1-19. Using 5/16-inch u-bolts and
flange nuts, install a boom foot (1) on each outer wing
(2).
Figure 1-19
Install Boom Foot
16946
17010