Great Plains 4000TM Assembly Manual - Manual (Page 20)

16 1800-3000TM Table of Contents Index Great Plains Manufacturing, Inc.
586-536E Table of Contents Index 04/12/2013
Depth Stop & Angle Gauge
Refer to Figure 15
Note: See machine layout drawings in Appendix for
proper gang gauge placement for each model.
60. Slide depth stop tube from rear of machine under
left wing stop through square hole on depth control
bracket on center wing brace. Align rear holes over
lever on torque tube, secure with 1/2 x 3 hex bolt
,
1/2 top lock nut.
61. Fasten depth stop assembly on top of depth stop
tube with 1/2 x 2 1/2 hex bolts , 1/2 lock washers
and nuts.
62. Attach angle gauge bracket assembly to front of
center frame with 1/2 x 3 1/32 x 6 u-bolts , 1/2 lock
washers and 1/2 nuts.
63. Attach gauge link to ear on front of center frame
and gauge bracket assembly , secure with 3/8 x 1
1/4 hex bolts and 3/8 top lock nuts.
64. Tighten all bolts with lock nuts snug, but do not
torque. The rest of the bolts may be tightened to
specs, See “Torque Values Chart” on page 38.
1
2
3
4
5
6
7
5
8
Figure 15
Depth Stop & Angle Gauge 42971
U
D
F
B
L
R
8
5
6
4
3
1
2
7