Great Plains 2015 Operator Manual - Manual (Page 4)

2015 Three-Point Soybean Machine 173-088M 4/18/05 2 Great Plains Mfg., Inc.
Using this Manual
This manual has been prepared to instruct you in the
safe and efficient operation of your 20’ 3-Point Soybean
Machine. Read and follow all instructions and safety pre-
cautions carefully.
Read and follow all instructions and safety precautions
carefully.
The parts on your drill have been specially designed and
should only be replaced with genuine Great Plains parts.
Therefore, should your drill require replacement parts go
to your Great Plains Dealer.
The right hand and left hand as used throughout this
manual is determined by facing in the direction the drill
will travel when in use unless otherwise stated.
Serial Number
The serial number plate is located on the front side of the
main frame tube, to the left of the 3-point hitch plate. It is
suggested that the serial number and purchase date
also be recorded for your convenience in the space pro-
vided on the checklist page at the beginning of this
manual.
The serial number provides important information about
your drill and may be required to obtain the correct re-
placement part. Always use the serial number and
model number when sending correspondence or when
ordering parts from your Great Plains Dealer.
The SAFETY ALERT SYMBOL indicates that there is a
!
potential hazard to personal safety involved and extra
safety precautions must be taken. When you see this
symbol, be alert and carefully read the message that fol-
lows it. In addition to design and configuration of
equipment; hazard control and accident prevention are
dependent upon the awareness, concern, prudence and
proper training of personnel involved in the operation,
transport, maintenance and storage of equipment.
Watch for the following safety notations through-out
your Operators Manual:
!
DANGER!
Indicates an imminently hazardous situation which, if
not avoided, will result in death or serious injury. This
signal word is limited to the most extreme situations.
!
WARNING!
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
!
CAUTION!
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
NOTE: Indicates a special point of information which
requires your attention.
For your safety and to help in developing a better under-
standing of your equipment we highly recommend that
you read the operator sections of this manual. Reading
these sections not only provides valuable training but
also familiarizes you with helpful information and its lo- cation. The parts sections are for reference only and
don’t require cover to cover reading. After reviewing your
manual store it in a dry, easily accessible location for fu-
ture reference.
Using this Manual
Introduction