Great Plains Electric Hydraulic Boom Solenoid Operator Manual 1995+ - Manual (Page 11)

4/17/2003 500-089M
9 Preparation and Setup
Preparation and Setup
Tractor Requirements
To operate your Great Plains Sprayer, a tractor using a 12
volt electrical system must be used.
The tractor will need two hydraulic outlets (one pair).
Before You Start
Read and understand the owners manual for your sprayer.
A basic understanding of how the sprayer works will aid in
the assembly, setup and operation of your sprayer.
Before attempting to assemble the sprayer, use the follow-
ing as a checklist. Having all the needed parts and
equipment readily at hand will speed up your assembly
task and will make the job as safe as possible.
1.
❑
Check for all sprayer components and hardware.
2.
❑
If a bolt, pin or other component has been re-
moved, or if you are unsure about where it is used, re-
fer to the parts section of this manual to identify it.
Trailer Sprayer
Control Box Assembly
The Trailer Sprayer control box incorporates the option for
the electric/hydraulic solenoid option within the control box
of the sprayer. The switches and wiring harness need to
be assembled into the Trailer Sprayer control box.
Refer to Figure 1
1. Remove the control box cover (1) and remove the plug
(2) out of the back of the control box.
2. Route the 833-040C wiring harness through the hole
where the plug was so that the terminals are inside the
box and the receptacle is on the outside of the box.
Figure 1
Trailer Sprayer Control Box Wiring Schematic
13922