Great Plains 1005NT Operator Manual - Manual (Page 13)

11
Section 2 Operating Instructions
4/12/05 705 and 1005 End-Wheel No-Till Drill 150-213M
Great Plains Mfg., Inc.
Parking
Perform the following steps when parking the drill. Refer to
Storage, “Maintenance and Lubrication,” page 29, to
prepare for long-term storage.
1. Park drill on a level, solid area.
2. Lower drill until openers are resting on ground.
3. Securely block tires to prevent rolling.
4. Remove tongue jack from storage stob. Pin jack on
side of tongue. If ground is soft, place a board or plate
under jack.
5. Extend jack until tongue weight is off tractor drawbar.
6. Unplug hydraulic hoses from tractor. Do not allow
hose ends to rest on ground.
7. Remove hitch bolt and safety chain from tractor draw-
bar.