Great Plains 1005NT Operator Manual - Manual (Page 4)

2
Important Safety Information
705 and 1005 End-Wheel No-Till Drill 150-213M 4/12/05
Great Plains Mfg., Inc.
Transport
Machinery Safely
Maximum transport speed for imple-
ment is 20 mph. Some rough terrains
require a slower speed. Sudden
braking can cause a towed load to
swerve and upset.
▲
Do not exceed 20 mph. Never
travel at a speed which does not
allow adequate control of steering
and stopping. Reduce speed if
towed load is not equipped with
brakes.
▲
Comply with state and local laws.
▲
Do not tow an implement that,
when fully loaded, weighs more
than 1.5 times the weight of tow-
ing vehicle.
Use Safety
Lights and Devices
Slow-moving tractors, self-propelled
equipment and towed implements
can create a hazard when driven on
public roads. They are difficult to see,
especially at night.
▲
Use flashing warning lights and
turn signals whenever driving on
public roads.
▲ Use lights and devices provided
with implement.
Practice Safe Maintenance
▲
Understand procedure before
doing work. Use proper tools and
equipment. Refer to this manual
for additional information.
▲ Work in a clean, dry area.
▲ Lower implement to ground, put
tractor in park, turn off engine,
and remove key before performing
maintenance.
▲ Allow implement to cool completely.
▲ Inspect all parts. Make sure parts
are in good condition and installed
properly.
▲ Remove buildup of grease, oil or
debris.
▲
Remove all tools and unused
parts from implement before oper-
ation.
Use A Safety Chain
▲ Use a safety chain to help con-
trol drawn machinery should it
separate from tractor drawbar.
▲
Use a chain with a strength rat-
ing equal to or greater than the
gross weight of towed machin-
ery.
▲ Attach chain to tractor drawbar
support or other specified
anchor location. Allow only
enough slack in chain to permit
turning.
▲ Replace chain if any links or end
fittings are broken, stretched or
damaged.
▲ Do not use safety
chain for towing.