Great Plains Detracker Assembly Instructions - Manual (Page 6)

589-386q 02/24/2014
2 Detracker Great Plains Manufacturing, Inc.
Assembly
Before You Start
Review these instructions, and make sure you under-
stand where and how the componets install to machine. Carefully un-band all componets and inventory the con-
tents on page.Assembly
Install Detracker Frame Assembly
See parts lists below for proper descriptions and comments.
Refer to Figure 2
1.
Attach detracker mount to center gang hanger
with plate , using bolts , lock washers and
nut . See “Prior Going To The Field” on page 5,
for proper placement. Repeat same procedure for
other side.
2. Mount shank to detracker mount tube by aligning
the holes in the two plates (one on each side).
Align holes in shank clamps on front side of
shank, secure assembly with bolts and lock
washers . These bolts thread into shank clamp.
See “Prior Going To The Field” on page 5, for
proper placement.
3. Now the set screws may be installed into the
shank clamps. Attach bolt through top hole in
shank, secure with lock nut .
4. Once every thing is adjusted, all bolts may be tight-
ened to specs, See “Torque Value Chart” on
page 6.
Detracker Frame Assembly Parts
Callout Part Number Description Comment
11 589-384H DETRACKER MOUNT
12 589-134D PART - DETRACKER
13 802-208C HHCS 5/8-11X8 GR5
14 804-022C WASHER LOCK SPRING 5/8 PLT
15 803-021C NUT HEX 5/8-11 PLT
16 204-026D SHANK 1 1/2D X 22 FERT COUL
17 204-038D CLAMP PLT 4 BAR
18 802-045C HHCS 1/2-13X5 GR
19 804-015C WASHER LOCK SPRING 1/2 PLT
20 204-072D CLAMP SHANK 1 1/2 DIA
21 801-040C SCREW SQ HD 5/8-11 X 1 CUP P
22 802-115C HHCS 5/16-18X2 GR5
23 803-011C NUT LOCK 5/16-18 PLT
Figure 2
Detracker Frame Assembly
41629
13
18
12
14
15 11
19
17
16
21
20
22
23
11
12 13 14
15
16
17
20
18
19
21
22
23