Great Plains YP625PD Operator Manual User Manual
Operator manual, Manufacturing, inc
Advertising
Manufacturing, Inc.
© Copyright 2011
Printed 02/23/2011
401-754M
EN
Operator Manual
YP625PD
18-Row 110 cm Yield-Pro
®
Air Planters
with Air-Pro
®
Seed Meters
Read the operator’s manual entirely. When you see this symbol, the
subsequent instructions and warnings are serious - follow without
exception. Your life and the lives of others depend on it!
Illustrations may show optional equipment not supplied with standard unit,
or may show similar 3-point models and their options.
31794
Advertising
Table of contents
Document Outline
- Operator Manual
- Table of Contents
- Important Safety Information
- Look for Safety Symbol
- Be Aware of Signal Words
- Prepare for Emergencies
- Be Familiar with Safety Decals
- Wear Protective Equipment
- Avoid High Pressure Fluids
- Use A Safety Chain
- Keep Riders Off Machinery
- Use Safety Lights and Devices
- Transport Machinery Safely
- Handle Chemicals Properly
- Shutdown and Storage
- Tire Safety
- Practice Safe Maintenance
- Safety At All Times
- Safety Decals
- Safety Reflectors and Decals
- 818-055C Slow Moving Vehicle Reflector
- 838-266C Red Reflectors
- 838-265C Amber Reflectors
- 838-267C Daytime Reflectors
- 818-337C Warning: Speed
- 818-339C Warning: High Pressure Fluid
- 818-682C Warning: Markers (Option)
- 838-363C Warning: Moving Parts Hazard
- 848-508C Warning: Rotating Fan
- 848-517C Warning: High Pressure Fluid Hazard
- 848-520C Warning: Possible Chemical Hazard
- 848-523C Warning: Crushing Hazard
- 818-587C Caution: Read Operator’s Manual
- 848-512C Caution: Read Operator’s Manual
- 848-708C Caution: Tire Pressure and Bolt Torque
- Introduction
- Preparation and Setup
- Operating Instructions
- Adjustments
- Setting Material Rates
- Fan and Adjustment
- Dry Fertilizer Adjustment
- Frame-Mounted Accessory Adjustments
- Marker Adjustments (Option)
- Gauge Wheel Height Adjustment
- 25AP Series Row Unit Adjustments
- Troubleshooting
- Maintenance and Lubrication
- Maintenance
- Material Clean-Out
- Meter Brush Maintenance
- Speed Sensor Gap
- Hydraulic Maintenance
- Drive-Line Shear Pin
- Marker Maintenance (Option)
- Chain Maintenance
- Spreaders and Scrapers
- Row-Unit Side Wheels
- Seed Flap Replacement
- Lubrication
- Opener Side Wheel Bushing
- Chain: Contact Drive, Lower
- Chain: Contact Drive, Upper
- Chains: Fertilizer Drive (Option)
- Chains: Meter Drive
- Chain: Range Drive
- Chain: Transmission Drive
- Gauge Wheel Module Forward Pivot
- Markers (Option)
- Coulter Hubs (Option)
- Coulter Pivot (Option)
- Tire Pressures
- Ground Drive Wheel Hub
- Gauge Wheel Hubs
- Markers: Disk Hub
- Seed Lubricants
- Options
- Appendix A - Reference Information
- Appendix B - Initial Setup
- Appendix C - Flat Ground Planting
- Index