Great Plains YP625PD Operator Manual - Manual (Page 40)

36 YP625PD Table of Contents Index Great Plains Manufacturing, Inc.
401-754M Table of Contents Index 02/23/2011
Short-Term Parking
1. Fold markers (page 32).
2. Choose a location with level firm ground. Do not
unhitch on a steep slope.
3. Fully raise planter.
4. Engage transport locks (page 19).
5. Lower planter onto locks.
6. (Option) Close discharge valves at fertilizer tank(s).
7. Set hydraulic circuits to neutral.
8. Disconnect hydraulic lines. Secure them so that they
do not touch the ground.
9. Disconnect electrical cables, capping where
provisioned.
10. Move jack from storage position to side of tongue.
11. Slightly raise tongue with jack.
12. Unhitch.
Restart tractor and pull away from planter.
Long-Term Storage
1. Clean-out fertilizer hoppers per “Dry Fertilizer
Clean-Out” on page 76.
2. Complete Parking steps (page 36). Park the planter
indoors if possible. Great Plains recommends
parking/storing in the raised position with transport
locks in place.
3. See “Material Clean-Out” on page 74. Clear all
seed from seed container, air box, seed delivery
system and meters.
4. Close slide gates and latch hopper lids.
5. Remove seed disks from meters (this is primarily to
relieve pressure on brushes). Clean disks of residue
build-up (see Caution below). Use mild soap,
non-abrasive scrubbers, and hot or warm water. If
using sealed storage, dry disks prior to storage.
Possible Chemical Hazard:
Seed disks will have talc and graphite residue, and may have
residues of hazardous seed treatments. Do not wash disks
where food is prepared, or where cookware or dinnerware is
washed. Wear gloves when washing disks. Avoid spray.
Although the disks are dishwasher-safe, do not wash them in
an appliance also used for food cookware or dinnerware.
6. Tie or tape a small plastic bag over ends of all seed
delivery tubes to prevent insects from entering or
nesting.
7. Close seed inlet shutters at meters (to prevent pest
entry to seed hoses). Thoroughly clean seed and
seed treatment residue from seed meters. See
“Meter Clean-Out” on page 75, for more information.
8. Clean planter of mud, dirt, excess oil and grease.
9. Lubricate all points listed in Maintenance.
10. Apply grease to exposed cylinder rods to prevent
rust.
11. Inspect planter for worn or damaged parts. Make
repairs and service during off season.
12. Use spray paint to cover scratches, chips, and worn
areas on the planter to protect the metal.
13. Cover planter with a tarp if stored outside.