Bio-Rad Firmware & Software Updates - Manual (Page 150)

CFX96 Touch, CFX96 Touch Deep Well, CFX Connect, and CFX384 Touch Systems Instruction Manual
137
polymerase, iTaq™ DNA polymerase, or other polymerases and the default amplicon
length
Figure 93. Protocol tab in the User Preferences window.
Plate Tab
Select the Plate tab in the User Preferences window (Figure 94) to specify the following default
settings for a new Plate file in the Plate Editor window:
• Plate Type. Select the default plate well type from the list
• Plate Size. Select the default plate size from the list
• Units. Select the units used to describe the concentration of the starting template for
wells that contain standards. The software uses these units to create a standard curve in
the Data Analysis Quantification tab
• Scientific Notation. Select scientific notation to view concentration units in that notation
• Scan Mode. Select a default scan mode to set the number of channels to scan during a
run
• Fluorophores. Click checkboxes to select the default fluorophores that appear in the
Plate Editor well loading controls
• Libraries. Enter the target and sample names that you typically use in your experiments.
Enter target names to list genes and sequences, and enter sample names to list
conditions for experiment samples. These names appear in the lists of the Targets tab
and Samples tab in the Experiment Settings window