BlueAnt Q1 Voice Controlled Headset - Manual (Page 27)

27
Using More Than One Phone At The Same
Time (Multipoint)
The Q1 supports multipoint technology. This means that you can use one Q1 headset with two
different mobile phones or Bluetooth devices at the same time: if either phone rings, you can answer
it with the Q1.
Multipoint also means that you can connect to both your phone and your Bluetooth-enabled computer
at the same time.
If I Have Two Phones Connected, Which One Will Be Used?
When you have two mobile devices connected to the Q1, the first one that connected to the Q1 is
designated the "primary phone". If you initiate a call through the Q1 it will happen on this phone.
This means that:
• You can answer a call received on either device.
• If you initiate a call through the Q1 (for example by using one of the calling commands, such as
"Call Speed Dial 1" or "Redial") then the call will be made on the primary phone (the phone that
connected to the Q1 first).
Please note that if the "first connected phone" goes out of range of the Q1 and then
comes back into range, it will no longer be the first connected phone. Any future calls
you initiate through the Q1 will now be made on the other phone.
Remember that for some calling commands, the phone number called depends on the phone used.
For example, the
"Redial" command uses the number of the last incoming call stored on the phone,
and so it will call a different number depending on which phone is used for the call.
If you are using the "Call Speed Dial" commands to call the numbers stored in your phone's speed
dial settings (rather than speed dial numbers stored on the Q1), then the number called will also