BlueAnt Q1 Voice Controlled Headset - Manual (Page 39)

39
Function Button How Long When Notes
Reject a Call Double
Click Ringing You can also answer or reject a call using
the voice commands.
Redial Last
Number "Vol +" Hold for 1
second Standby,
Active Call This command tells the connected phone
to redial its last outgoing call (it doesn't
matter whether the phone was connected
to the Q1 at the time that call was made).
If you use this button function while you
are on an active call, the current call will
be put on hold while the Q1 dials the call.
Use Phone Voice
Dialing Click Standby
(Voice
Control
Off) This function is only available through
this button press if you have turned off
voice control (either through the
"Settings
Menu" or by using the button combination
described below).
If voice control is turned on, then you can
access your phone's voice dialing feature
by using the voice command
"Phone
Commands" instead.
Switch Voice
Isolation
between
Standard and
Max Double
Click Active Call,
3 Way Call You will hear an audio confirmation of the
current voice isolation setting when you
switch between them.
Please note that this button press changed
in firmware version 8.19. If you have an
older firmware release on your Q1, then
you switch modes by single clicking the
BlueAnt button.
Mute "Vol +"
and
"Vol -"
Hold
together
for 1
second
(until you
hear a
beep) Active Call,
3 Way Call This function mutes the audio on the
current call. You will hear a beep every 20
seconds to remind you that the audio is
muted.
Repeat the button combination to undo the
mute.