BlueAnt Q1 Voice Controlled Headset - Manual (Page 28)

28
depend on which phone is used. See "Setting Up Speed Dials" (page 23) for more information about
the two different types of speed dial you can use with the Q1.
Switching Between Calls and Phones
If you have two phones connected to the Q1, and you receive a call on one of them while you are
already on a call on the other phone, then you can use the Q1's buttons to answer the second call.
• To put your current call on hold and answer the incoming call, hold down the "Vol +" button for 1
second.
• To end the current call and answer the incoming call, hold down the "Vol -" button for 1 second.
• Once you have a call on hold, you can switch between the two calls by holding down the "Vol +"
button for 1 second.
You can also answer the call on the second phone using that phone's handset. However, if you do
this, some phone models will keep the audio for that call on the handset, while other phone models
automatically route the audio back to the Q1, putting your first call on hold. In order to be certain
about where you will hear the audio, you are therefore recommended to always use the Q1 buttons if
you want to answer the call.
If you do answer the second call using the second phone handset and find that the call audio is on the
phone rather than the Q1, then you can transfer that audio back to the Q1 by holding down the
"Vol +"
button for 1 second. This will place the first call on hold.