BlueAnt Q1 Voice Controlled Headset - Manual (Page 40)

40
Function Button How Long When Notes
Disconnect the
headset (transfer
audio to the
phone) "Vol +"
and
"Vol -"
Click Standby,
Ringing,
Active Call,
3 Way Call You can use this function to disconnect the
Q1 headset from the phone during a call.
The audio will transfer to the phone where
you can continue the conversation.
Click the buttons again to transfer audio
back to the Q1 again, although please note
that not all phones support transferring
audio back to the headset.
You can also use this function to
disconnect the Q1 if you are not on a call,
although in this case you will not be able to
reconnect to the Q1 by clicking the buttons
again (to reconnect in this case, you can
use the
"Am I Connected" voice command
instead).
Reconnect to the
Phone Click Idle (Voice
Control
Off) This function is only available through
this button press if you have turned off
voice control (either through the
"Settings
Menu" or by using the button combination
described below).
If voice control is turned on, then you can
reconnect to your phone by using the
"Am
I Connected?" voice command instead.
Turn Voice
Control On or Off "Vol +"
and
"Vol -"
Hold for 3
seconds Idle,
Standby You can also turn off voice control by using
the
"Turn Off Voice Control" option on the
"Settings Menu".