BlueAnt Q1 Voice Controlled Headset User Manual
Page 36
36
Command
Say This To...
"Sensitivity Level"
Change the sensitivity level of the Q1's voice recognition. This
setting determines how precisely the words that you say need to
match the speech patterns that the Q1 has been configured to
recognize. You can set this to
"High", "Medium", or "Low".
When the level is set to
"High" the commands you give the Q1 will
need to match the speech pattern it is expecting more exactly,
while
"Low" is less restrictive and will accept your commands
even if they don't precisely match the expected speech pattern.
If you find that the Q1 is not recognizing your voice commands at
all, you should change to a lower sensitivity level.
You may wish to switch to a higher sensitivity level if the Q1 often
responds to your voice commands by carrying out the wrong
command.
"Incoming Call Function"
Turn the incoming call function on or off.
If you turn the incoming call function off, then the Q1 will not
announce the number of any incoming calls, and you will not be
able to answer calls using your voice.
"Say A Command Prompt"
Turn the
"Say A Command" prompt on or off. If you turn off the
prompt, you will hear a beep instead.
"Turn Off Voice Control"
Turn off voice control. If you turn off the voice control, then you
will only be able to control the Q1 using the buttons. See
for a full list of the available controls.
"LED Light"
Turn the LED Light on or off.
When you turn the LED off, it will still light up when you turn the
Q1 on and off, but not at other times.
"Reset the Q1"
Reset the Q1 and go back to pair mode. Resetting the Q1 deletes:
• All stored pairings.
• Any speed dial numbers stored in the Q1.
• The details of the last incoming call.