Humboldt HM-1327 Humboldt Marshall/TSR Loader - Manual (Page 12)

Set Up Key
Pushing the Set Up Key brings up the main set up screen
from which you can run a test, review your last test, access
the engineering set up menus and set the date, time, units,
standards criteria. This key also is used to return to a previous
screen.
Up Key
Pushing the Up Key allows you to move the platen up to
facilitate testing. When the key is pushed the green light
next to it is lit.
Stop Key
Pushing the Stop Key stops platen movement. When the key is
pushed the red light next to it is lit.
Down Key
Pushing the Down Key allows you to move the platen down.
When the key is pushed the green light next to it is lit.
Function Keys
The four function keys are used to navigate through the
HM-1327’s menu-driven display. The function keys
correspond with the command lines on the HM-1327’s menu
display. F1 corresponds with the first command line; F2, the
second, etc. Command lines that are active in any display will
be proceeded by an (*). If no (*) is present, the corresponding
function key is not active.
9
Humboldt HM-1327
STAB = 1.2 lbs
FLOW = 0.003 in
Except when viewing inputs values as above left, the function keys will
perform a tare function to the displayed value and "T" will be displayed
next to the input name to indicate that the value of the input has a tare
(above right).
Humboldt HM-1327
STAB T = 0.0 lbs
FLOW T = 0.000 in