Humboldt HM-1327 Humboldt Marshall/TSR Loader - Manual (Page 16)

Press you will see this screen:
Press (DATE/UNIT/STANDARD). You should see this screen:
Press (units) to toggle between English and Metric Units.
Select the standard desired—the flashing standard is the active choice.
To return to any prior screen you can always press
Set Standards
To set the Standards the HM-1327 will use, press
until you see this
screen:
Press you will see this screen:
Press you will see this screen:
13
* DATE/UNIT/STANDARD
* MANUFACTURES INFO
* CHANGE DATE
* CHANGE TIME
* UNIT = ENGLISH/METRIC
* STANDARD = ASTM/BS
* REVIEW LAST TEST
* RUN TEST
* MORE SETUP
* ENGINEERING SETUP
* SENSOR LIMITS OFF
* RAW_DATA
* MORE SETUP
* RECALL CALIBRATION
* CHANGE DEVICE ID
* MORE SETUP