Humboldt HM-1327 Humboldt Marshall/TSR Loader - Manual (Page 15)

12
Press (DATE/UNIT/STANDARD). You should see this screen:
Press (CHANGE TIME). You should see this screen:
Press (TIME) to select the HOURS/MINUTES/SECONDS. Press
(INCREASE). or Press (DECREASE) to change the appropriate number.
To return to any prior screen you can always press
* TIME = "HH/MM/SS"
* INCREASE
* DECREASE
* CHANGE DATE
* CHANGE TIME
* UNIT = ENGLISH/METRIC
* STANDARD = ASTM/BS
Set Units
To set the Units the HM-1327 will use to display results, press
until
you see this screen:
Press you will see this screen:
Press you will see this screen:
* REVIEW LAST TEST
* RUN TEST
* MORE SETUP
* ENGINEERING SETUP
* SENSOR LIMITS OFF
* RAW_DATA
* MORE SETUP
* RECALL CALIBRATION
* CHANGE DEVICE ID
* MORE SETUP