Integra LifeSciences LED Loupes Light Source, Portable - Manual (Page 3)

2. Attach the lamp head to loupes using the supplied mount.
a. For Miltex ® , PeriOptix ® , Surgitel ® , Orascoptic ® , Zeiss ® GF and other flip style loupes:
Slide clip onto front of interpupillary cross bar of loupes, with one circular cut out on top and
one cut out on the bottom of the cross bar. The clip should securely snap into place.
b. For through-the-lens (TTL) solid bridge mount: Loosen the thumb nut on bridge clamp,
opening the two halves wide enough to engage the top and bottom of frame nose bridge. Attach
the clamp to the bridge and tighten nut. Note: the tightening nut should be oriented up (towards
the ceiling) when the clamp is attached to the nose bridge.
3. Remove the battery from the charger unit and slide into the battery case.
The battery should snap into place.
4. Clip the battery case to your waist band or pocket.
a. Attach the lamp cord to the loupes frames with the small elastic strap.
b. Use the shirt clip on the lamp cord to position the cord on your shirt or lab coat as desired.
5. Turn on lamp using on/off switch.
a. The intensity control knob will adjust lamp intensity.
6. Adjust the direction of the LED beam.
a. To adjust the tension of the lamp head position, use the supplied Philips screwdriver to tighten or
loosen the two (2) small link screws as needed.
For any questions or problems, please call Miltex Customer Service at 866-854-8300
Warranty: Miltex warrants its products to be free of original defects in material and workmanship
and to perform in accordance with specifications for the following terms:
30 Day Trial Period:
LED lamp head, cables, chargers and battery pack. If any issues should arise
during the first 30 days, Miltex will replace the above components free of charge.
Limitations of Warranty:
• Breakage or failure due to tampering, misuse, neglect, accidents, modification or shipping.
• If the product is not used in accordance with manufacturer’s recommendations or instructions.
• If repaired or serviced by other than Miltex or a Miltex authorized representative.
• Prompt inspection and reporting of missing or damaged product should be made to shipping
carrier and Miltex with 3 days of receipt of product.
• If Miltex products or any component thereof are found to be defective or at variance with the
manufacturer’s specifications during the warranty period, Miltex will repair or replace the product
or component(s) at no cost to the purchaser. This warranty only applies to products purchased new
from Miltex or its authorized distributors or representatives.
• The purchaser must return the product directly to Miltex or an authorized distributor or
representative and bear the costs of shipping.
• This is the only warranty made by Miltex. Miltex makes no other warranty, express or implied,
including any warranty of merchantability and fitness for a particular purpose.