NISSAN 2012 GT R - Owner's Manual - Manual (Page 207)

Black plate (210,1)
R35-D EDITED: 2011/ 2/ 4
5-14 Starting and driving
NOTE:
. If the engine is difficult to start, de-
press the accelerator pedal all the way
to the floor and hold it. Push the
ignition switch with the brake pedal
depressed to start cranking the engine.
After 5 or 6 seconds, stop cranking by
pushing the ignition switch to the OFF
position, and then release the accel-
erator pedal. Then perform steps 1 to 5
to start the engine. If the engine starts,
but fails to run, repeat this procedure.
. Starting and stopping the engine over a
short period of time may make the
vehicle more difficult to start. If this
occurs, wait for more than 3 minutes,
and then press the ignition switch
again to start the engine.
. To maintain high performance over a
long period of time, the engine speed is
limited to 5,000 rpm when the engine is
revved with the shift lever in the
&
N or
&
P position, and to 4,000 rpm when the
engine oil or coolant temperature is
low or higher than normal.
. If the ignition switch is pressed before
the shift lever is moved to the
&
P
position, the ignition switch will not
change to the OFF position. If this
occurs, the SHIFT
&
P warning display
appears on the vehicle information
display. When stopping the engine, be
sure to move the shift lever to the
&
P
position and then press the ignition
switch. Failure to do so may result in
discharge of the battery. (
“Shift
“P” warning” page 2-41)
. If the shift lever was in the &
A
↔ &
M or
&
R
position when the engine was stopped,
then be sure to move the shift lever to
the
&
P position before starting the
engine the next time. If the engine is
started with the shift lever in the
&
N
position, then it may not be possible to
drive the vehicle even when the shift
lever is moved to the
&
A
↔ &
M or
&
R
position. If this occurs, the SHIFT
&
P
warning appears on the vehicle infor-
mation display. (
“Shift “P” warn-
ing” page 2-41)
CAUTION
If the engine was stopped soon when
the engine is hot, the cooling fan may
operate for approximately 2 minutes
after the engine was stopped to cool
the components in the engine compart-
ment. When the cooling fan is operat-
ing, be sure that hands or other items
do not get caught in it.