NISSAN 2012 GT R - Owner's Manual - Manual (Page 226)

Black plate (229,1)
R35-D EDITED: 2011/ 2/ 4
HOW TO USE R MODE START
FUNCTION
1. Move the shift lever to the
&
A or
&
M position.
2. Select the R mode with the transmission
setup switch. ( “VDC, transmission and
suspension setup switches” page 5-24)
3. Select the R mode with the VDC setup
switch.
4. Depress the brake pedal firmly with your left
foot and keep depressing the brake pedal.
5. Depress the accelerator pedal quickly to the
floor with your right foot while the brake
pedal is depressed. The engine speed will
increase to approximately 4,000 rpm and
will be maintained.
6. Within 3 seconds after depressing the
accelerator pedal, release the brake pedal.
WARNING
. Be sure the parking brake is fully
released before driving. Failure to
do so can cause brake failure and
lead to an accident.
. Do not release the parking brake
from outside the vehicle.
. Do not use the gear shift in place of
the parking brake. When parking, be
sure the parking brake is fully
engaged.
. Do not leave children unattended in
a vehicle. They could release the
parking brake and cause an acci-
dent.
To apply: Pull the parking brake lever up.
To release:
1. Firmly apply the foot brake.
2. While pulling up on the parking brake lever
slightly, push the button
*
A and lower the
lever completely.
3. Before driving, be sure the brake warning
light goes out.
Starting and driving 5-33
PARKING BRAKE