NISSAN 2012 GT R - Owner's Manual - Manual (Page 345)

Black plate (353,1)
R35-D EDITED: 2011/ 2/ 4
FUEL RECOMMENDATION
VR38 engine
Use unleaded premium gasoline with an octane
rating of at least 93 AKI (Anti-Knock Index)
number (Research octane number 98) to max-
imize vehicle performance.
If the premium gasoline specified above is not
available, you may use unleaded premium gaso-
line with an octane rating of at least 91 AKI
number (Research octane number 96), but you
may notice a decrease in performance.
Do not use gasoline with a lower octane rating
than 91 AKI (Research octane number 96).
NOTICE
. Using a fuel other than that speci-
fied could adversely affect the emis-
sion control systems, and may also
affect warranty coverage.
. Under no circumstances should a
leaded gasoline be used, since this
will damage the three way catalyst.
. Do not use E-85 fuel in your vehicle.
Your vehicle is not designed to run
on E-85 fuel. Using E-85 fuel can
damage the fuel system compo-
nents. See the 2012 NISSAN GT-R
Warranty Information Booklet for
details and exclusions.
. NISSAN recommends using fuels
that contain no alcohol. However,
fuels containing up to 10% alcohol
may be used, if necessary. To avoid
serious engine damage due to in-
creased cylinder temperature, do
not use fuels that contain more
a l c o h o l
t h a n i n d i c a t e d i n
“Gasoline containing oxyge-
nates” page 9-4. Also, do not use
fuel additives, fuel stabilizers or fuel
deicers that contain alcohol.
For additional information, see the following
section. (
“Capacities and recommended
fuel/lubricants” page 9-2)
ENGINE OIL RECOMMENDATION
Mobil 1 (0W-40) (100% synthetic) is the factory
fill oil. The VR38 engine with its plasma-sprayed
bores was developed using this oil. NISSAN
cannot ensure proper engine operation and
durability if other 0W-40 synthetic oil is used.
If Mobil 1 (0W-40) is not available, Mobil 1
(10W-40) (100% synthetic) may be used;
however, some performance loss may be
noticed.
See the following section for engine oil and oil
filter recommendation. (
“Capacities and
recommended fuel/lubricants” page 9-2)
COLD TIRE PRESSURES
The label is typically located on the driver side
center pillar or on the driver’s door.
(
“Wheels and tires” page 8-31)
NEW VEHICLE BREAK-IN PROCE-
DURES RECOMMENDATION
Follow these recommendations for the future
reliability and economy of your new vehicle.
During the first 1,200 miles (2,000 km) of
vehicle use, follow the recommendations out-
lined in this Owner’s Manual. (
“Break-in
schedule” page 5-39)
GAS STATION INFORMATION