NISSAN 2012 Murano - Owner's Manual - Manual (Page 122)

2-32 Instruments and controls
SIC3922
Type C
The windshield wiper and washer operates
when the ignition switch is in the ON position.
Push the lever down to operate the wiper at the
following speed:
*
1 INT (Type A or Type C) — intermittent operation
can be adjusted by turning the knob toward
*
A
(Slower) or
*
B (Faster).
*
1 AUTO (Type B) — For models with the rain-
sensing auto wiper system, see “Rain-sensing
auto wiper system” later in this section.
*
2 LO — continuous low speed operation
*
3 HI — continuous high speed operation
Push the lever up
*
4 (MIST) to have one sweep
operation of the wiper.
Pull the lever toward you
*
5 to operate the
washer. Then the wiper will also operate several
times.
SIC4017
RAIN-SENSING AUTO WIPER SYS-
TEM (if so equipped)
The rain-sensing auto wiper system can auto-
matically turn on the wipers and adjust the wiper
speed depending on the rainfall and the vehicle
speed by using the rain sensor located on the
upper part of the windshield.
To set the rain-sensing auto wiper system, push
the lever down to the AUTO position
*
1 . The
wiper will sweep once while the ignition switch
is in the ON position.
The rain sensor sensitivity level can be adjusted
by turning the knob toward the front
*
2 (High)
or toward the rear
*
3 (Low).