NISSAN 2012 Murano - Owner's Manual - Manual (Page 389)

SCE0869
3. Remove the cap from the tire sealant bottle,
and screw the bottle clockwise onto the
bottle holder. (Leave the bottle seal intact.
Screwing the bottle onto the bottle holder
will pierce the seal of the bottle.)
4. Remove the cap from the tire valve on the
flat tire.
SCE0870
5. Remove the protective cap
*
A of the hose
and screw the hose securely onto the tire
valve. Make sure that the pressure release
valve
*
B is securely tightened. Make sure
that the air compressor switch is in the OFF
(
*) position, and then insert its power plug
into the power outlet in the vehicle.
SCE0871
6. Push the ignition switch to the “ACC”
position. Then turn the compressor switch
to the ON (
−) position and inflate the tire up
to the pressure that is specified on the tire
and loading information label affixed to the
driver’s side center pillar if possible, or to the
minimum of 180 kPa (26 psi). Turn the air
compressor off briefly in order to check the
tire pressure with the pressure gauge.
If the tire is inflated to higher than the
specified pressure, lower the tire pressure
by releasing air with the pressure release
valve.
In case of emergency 6-13