NISSAN 2012 Murano - Owner's Manual - Manual (Page 307)

SAA1858
Giving voice command:
1. Push and release the switch located on
the steering wheel.
SAA2574
2. A list of commands appears on the screen,
and the system announces, “Please say a
command after the beep. Available com-
mands are: Call, Phonebook, Recent Calls,
Connect Phone or Help”.
3. After the tone sounds and the icon on the
screen changes from to , speak a
command. See the “Using system” later in
this section for the voice command list.
Speak “Call” for example.
INFO
Voice commands cannot be recognized as
long as the screen icon is not in the
command recognition mode
.
4. The system acknowledges the command
and announces the next set of available
commands.
5. After the tone sounds, speak the phone
number.
6. When you have finished speaking the phone
number, the system repeats it back and
announces the available commands.
7. After system responds, speak “Dial” and the
system dials the spoken numbers.
Operating tips:
. Voice commands cannot be accepted when
the icon is .
. If the command is not recognized, the
system announces, “Please say again”.
Repeat the command in a clear voice.
. Push the switch or the BACK button
once to return to the previous screen.
. If you want to cancel the command, push the
switch. The message “Voice input is
canceled” will be announced. If you want to
adjust the volume of the system feedback,
push the volume control buttons [+] or [
−]
on the steering wheel or use the audio
system volume knob while the system is
making an announcement.
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-97