NISSAN 2012 Murano - Owner's Manual - Manual (Page 148)

2-58 Instruments and controls
SIC3801
Sliding sunshade and moonroof
When the moonroof switch is pushed to the
OPEN position
*
1 , the front and rear sun-
shades will fully open. When the switch is
pushed again, the moonroof will fully open.
When the moonroof switch is pushed to the
CLOSE position
*
2 , the moonroof will auto-
matically close. Push the switch again, and the
front and rear sunshades will close.
When the moonroof switch is pushed to the
second detent to the OPEN
*
3 or CLOSE
*
4
position, both the sunshade and moonroof will
open or close.
To stop the sunshades or moonroof during the
operation, push the moonroof switch to either of
the OPEN
*
1 , CLOSE
*
2 or UP
*
5 position.
Tilting moonroof
To tilt up the moonroof, push the moonroof
switch to the UP position
*
5 .
To tilt down the moonroof, push the switch to the
UP position
*
5 or push the switch to the
CLOSE position
*
2 .
When the moonroof is tilted up, push the
moonroof switch to the second detent to the
CLOSE position
*
4 . The moonroof will tilt down
and the sunshades will close.
Auto reverse function
WARNING
There are some small distances imme-
diately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., in-
side the vehicle before closing the
moonroof.
If the control unit detects something caught in
the moonroof and sunshades when they are
closing, the moonroof will be immediately
opened.
The auto reverse function can be activated when
the moonroof and sunshades are closed by
automatic operation when the ignition switch is
in the ON position or for about 45 seconds after
the ignition switch is pushed to the OFF
position.
If the moonroof and sunshades cannot be
closed automatically when the auto reverse
function activates due to a malfunction, push
and hold the switch to the CLOSE position
*
2 .
Depending on the environment or driving
conditions, the auto reverse function may
be activated if an impact or load similar to
something being caught in the moonroof
occurs.
If the moonroof does not operate
If the moonroof does not operate properly,
perform the following procedure to initialize the
moonroof operation system.
1. If the moonroof is open, close it fully by
pushing the switch to the CLOSE position
*
2 .
2. Push and hold the switch to the CLOSE
position
*
2 .
3. Release the moonroof switch after the
moonroof or sunshade moves slightly to
the closed position.