Programming homelink – NISSAN 2015 Quest - Owner's Manual User Manual
Page 141
2-60
Instruments and controls
PROGRAMMING HomeLink
If you have any questions or are having difficulty
programming your HomeLink
buttons, refer to
the HomeLink
web site at: www.homelink.com
or call 1-800-355-3515.
NOTE:
It is also recommended that a new battery
be placed in the hand-held transmitter of
t h e
d e v i c e
b e i n g
p r o g r a m m e d
t o
HomeLink
for quicker programming and
accurate transmission of the radio-fre-
quency.
1. Position the end of your hand-held transmit-
ter 1-3 in (26-76 mm) away from the
HomeLink
surface, keeping the HomeLink
indicator light
*
1
in view.
JVI0428X
2. Using both hands, simultaneously press and
hold the desired HomeLink
button and
handheld transmitter button. DO NOT re-
lease until the HomeLink
indicator light
*
1
flashes slowly and then rapidly. When the
indicator light flashes rapidly, both buttons
may be released. (The rapid flashing indi-
cates successful programming.)
NOTE:
Some devices to be programmed may
require you to replace Step 2 with the
cycling procedure noted in the “Pro-
gramming HomeLink
for Canadian
Customers and gate openers” (P.2-61).
JVI0429X
3. Press and hold the programmed HomeLink
button and observe the indicator light.
.
If the indicator light
*
1
is solid/contin-
uous, programming is complete and your
device should activate when the
HomeLink
button is pressed and re-
leased.
.
If the indicator light
*
1
blinks rapidly for
two seconds and then turns to a solid/
continuous light, continue with Steps 4-6
for a rolling code device. A second
person may make the following steps
easier. Use a ladder or other device. Do
not stand on your vehicle to perform the
next steps.