NISSAN 2015 Quest - Owner's Manual - Manual (Page 234)

button (the one with the indicator light
on) for more than 2 seconds to set the
automatic control between the air recir-
culation and outside air circulation
modes. (The “
” or “ ” indicator
light will blink twice.)
The following conditions need to be met for the
automatic air intake control mode to function
properly.
. The air flow control is not in the front
defroster mode (the indicator light on the
front defroster “
FRONT” button is
turned off).
. The outside temperature is approximately
32 8F (08C) or above.
NOTE:
. Do not set the temperature lower than
the outside air temperature. Doing so
may prevent the temperature from
being controlled properly.
. To dehumidify the air, push the “A/C”
button before turning on the heater.
Dehumidified defrosting/defogging:
1. Push the front defroster “ FRONT”
button. (The indicator light will illuminate.)
2. Push the temperature control buttons
(“ ” and “ ”) to set the desired
temperature.
. To remove frost from the outside surface
of the windshield quickly, set the tem-
perature control and fan speed control to
their maximum position.
. After the windshield is cleared, push the
“AUTO” button to set to the automatic
mode.
. When the front defroster “ FRONT”
button is pushed, the air conditioner will
automatically turn on sensing the outside
air temperature to defog the windshield.
Do not select the air recirculation mode
for the best defogging performance.
NOTE:
Do not set the temperature too low when
the front defroster mode is on (the indi-
cator on the front defroster “
FRONT”
button is illuminated). Doing so may fog
up the windshield.
Manual operation
The manual mode can be used to control the
heater and air conditioner to your desired
settings.
Fan speed control:
Push the fan speed control button “ ” to
increase the fan speed.
Push the fan speed control button “ ” to
decrease the fan speed.
Push the “AUTO” button to change the fan
speed to the automatic mode.
Air flow control:
Push the “MODE” button to change the air flow
mode.
: Air flows from the center and side ventila-
tors.
: Air flows from the center and side ventila-
tors, and foot outlets.
: Air flows mainly from the foot outlets.
: Air flows from the defroster and foot outlets.
Temperature control:
Push the temperature control buttons (“ ”
and “ ”) to set the desired temperature.
Air recirculation:
Push the air recirculation “ ” button to
recirculate interior air inside the vehicle. The
indicator light on the air recirculation “
”
Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-51