NISSAN 2011 Rogue - Owner's Manual - Manual (Page 102)

Black plate (100,1)
Model "S35-D" EDITED: 2010/ 6/ 4
SIC3484
Headlight beam select
*
1 To select the low beam, put the lever in the
neutral position as shown.
*
2 To select the high beam, push the lever
forward while the switch is in the
position. Pull it back to select the low beam.
*
3 Pulling the lever toward you will flash the
headlight high beam even when the head-
light switch is in the OFF position.
Battery saver system
. When the headlight switch is in the or
position while the ignition switch is in
the ON position, the lights will automatically
turn off 5 minutes after the ignition switch
has been turned to the OFF position.
. When the headlight switch remains in the
or position after the lights
automatically turn off, the lights will turn on
when the ignition switch is turned to the ON
position.
CAUTION
. When you turn on the headlight
switch again after the lights auto-
matically turn off, the lights will not
turn off automatically. Be sure to
turn the light switch to the OFF
position when you leave the vehicle
for extended periods of time, other-
wise the battery will be discharged.
. Never leave the light switch on
when the engine is not running for
extended periods of time even if the
headlights turn off automatically.
SIC2275
Headlight aiming control (if so equipped)
Depending on the number of occupants in the
vehicle and the load it is carrying, the headlight
axis may be higher than desired. If the vehicle is
traveling on a hilly road, the headlights may
directly hit the rearview mirror of the vehicle
ahead or the windshield of the oncoming
vehicle. The light axis can be lowered with the
operation of the switch.
The larger the number designated on the switch,
the lower the axis.
When traveling with no heavy load or on a flat
road, select position 0.
2-34 Instruments and controls