NISSAN 2011 Rogue - Owner's Manual - Manual (Page 195)

Black plate (195,1)
Model "S35-D" EDITED: 2010/ 6/ 4
SAA3427
Interface system for iPod ® operation
Connecting iPod ® :
The iPod ® outlet connector is located in the
center console. Connect the cable
*
1 as
illustrated, and then connect the other end of
the cable to your iPod
®
*
2 . Your vehicle is
equipped with the specialized cable for con-
necting the iPod
® to your vehicle audio unit. The
battery of your iPod ® is charged while it is
connected to the vehicle if the iPod ® supports
charging via a FireWire ® connection.
When the connection is complete, a NISSAN
logo will be displayed on the iPod
® and an iPod ®
icon on the audio display illuminates. While
connecting the iPod
® to the vehicle, the iPod ®
can only be operated by the vehicle audio
controls.
To disconnect the cable from the vehicle outlet,
fully depress the center connector button to
unlatch the connector and pull the connector
straight out of the outlet. To disconnect the
cable from the iPod
® , fully depress the side
connector buttons and pull the iPod ® connector
straight out of the iPod ® .
* iPod ® , iPhone ® and FireWire ® are a trademark
of Apple Inc., registered in the U.S. and other
countries.
Compatibility:
The following models are available:
. Fourth generation iPod ® (Firmware version
3.1.1 or later)
. Fifth generation iPod ® (Firmware version
1.1.2 or later)
. First generation iPod Classic ® (Firmware
version 1.3 or later)
. Second generation iPod Classic ® (Firmware
version 1.3 or later)
. First, second and third generation iPod
touch ® (Firmware version 3.1.0 or later)
. First and second generation iPod mini ®
(Firmware version 1.4.1 or later)
. iPod photo ® (Firmware version 1.2 or later)
. First generation iPod nano ® (Firmware ver-
sion 1.3.1 or later)
. Second generation iPod nano ® (Firmware
version 1.1.3 or later)
. Third generation iPod nano ® (Firmware
version 1.2 or later)
. iPhone ® (Firmware version 3.1 or later)
. iPhone ® 3G (Firmware version 3.1 or later)
. iPhone ® 3GS (Firmware version 3.1 or later)
The fourth and fifth generation iPod nano ® , iPod
touch ® , the second generation iPod Classic ®
and iPhone ® 3G may not work with the system
in some cases.
Make sure that your iPod ® firmware is updated.
* 12V-charge iPod ® s are not chargeable with
this system.
iPod ® button:
Place the ignition switch in the ACC or ON
position. Then, push the iPod
® button to switch
to the iPod ® mode.
If another audio source is playing and the iPod ®
is connected, pushing the iPod ® button changes
to the iPod ® mode.
Center display, heater, air conditioner, audio, phone and voice recognition systems 4-37