NISSAN 2011 Rogue - Owner's Manual - Manual (Page 92)

Black plate (90,1)
Model "S35-D" EDITED: 2010/ 6/ 4
average fuel consumption by the value above the
bar graph, the position of the diamond icon and
the value of
f since the last reset. Resetting the
average fuel consumption is done by pushing
and holding the
switch
*
A for less than 3
seconds.
The display is updated every 30 seconds. At
about the first 0.3 mile (500 m) after a reset, the
display shows “----”.
2. Average speed (MPH or km/h)
The average speed mode shows the average
vehicle speed since the last reset. Resetting is
done by pushing and holding the
switch
*
B for less than 3 seconds.
The display is updated every 30 seconds. For
the first 30 seconds after a reset, the display
shows “----”.
3. Driving Distance (miles or km)
The Driving Distance mode shows the distance
driven since the last reset. The driving distance
can be reset by pushing and holding the
switch
*
A for less than 3 seconds.
4. Elapsed time
Elapsed time:
The elapsed time mode shows the time since
the last reset. The displayed time can be reset
by pushing and holding the
switch
*
A for
less than 3 seconds.
5. Range (distance to empty) (dte —
miles or km)
The distance to empty (dte) mode provides you
with an estimation of the distance that can be
driven before refueling. The dte is constantly
being calculated based on the amount of fuel in
the fuel tank and the actual fuel consumption.
The display is updated every 30 seconds.
The dte mode includes a low range warning
feature. If the fuel level is low, the warning is
displayed on the screen.
When the fuel level drops even lower, the dte
display will change to “----”.
. If the amount of fuel added is small, the
display just before the ignition switch is
turned to the “OFF” position may continue to
be displayed.
. When driving uphill or rounding curves, the
fuel in the tank shifts, which may momenta-
rily change the display.
SIC4542
6. Settings
Setting cannot be made while driving.
The switch
*
A is used to select and set
the item.
Turn the
*
A switch to select or adjust and
push to set.
Clock:
Clock adjustment can be set on this menu.
. Set Clock
Adjust the time (hour and minute) of the
clock.
2-24 Instruments and controls