Control buttons -61 getting started -61 – NISSAN 2011 Rogue - Owner's Manual User Manual

Page 219

Advertising
background image

Black plate (219,1)

Model "S35-D" EDITED: 2010/ 6/ 4

SAA1782

CONTROL BUTTONS

The control buttons for the Bluetooth

®

Hands-

Free Phone System are located on the steering
wheel.

PHONE SEND

Push the

button to initiate a VR session or

answer an incoming call.

You can also use the

button to interrupt

system feedback and give a command at once.

PHONE END

While the voice recognition system is active,
push the

button to go back one step. Push

and hold the

button for 5 seconds to quit

the voice recognition system at any time.

GETTING STARTED

The following procedures will help you get
started using the Bluetooth

®

Hands-Free Phone

System with NISSAN Voice Recognition. For
additional command options, refer to “LIST OF
VOICE COMMANDS” later in this section.

Choosing a language

You can interact with the Bluetooth

®

Hands-Free

Phone System using English, Spanish or French.

To change the language, perform the following.

1. Push and hold the

button for more than

5 seconds.

2. The system announces: “Push the PHONE

SEND (

) button for the hands-free

phone system to enter the speaker adapta-
tion mode or push the PHONE END (

)

button to select a different language.”

3. Push the

button.

For information on speaker adaptation, see
“SPEAKER ADAPTATION (SA) MODE”
later in this section.

4. The system announces the current language

and gives you the option to change the
language to Spanish (in Spanish) or French
(in French). Use the following chart to select
the language.

NOTE:
You must push the

button or the

button within 5 seconds to change

the language.

Current lan-

guage

Push

(TALK/PHONE

SEND) to select

Push

(MODE/

PHONE END)

to select

English

Spanish

French

Spanish

English

French

French

English

Spanish

5. If you decide not to change the language, do

not push either button. After 5 seconds, the
VR session will end, and the language will
not be changed.

Connecting procedure

NOTE:

The connecting procedure must be per-
formed when the vehicle is stationary. If
the vehicle starts moving during the pro-
cedure, the procedure will be cancelled.

Center display, heater, air conditioner, audio, phone and voice recognition systems

4-61

Advertising
This manual is related to the following products: