NISSAN 2013 Rogue - Owner's Manual - Manual (Page 225)

Black plate (223,1)
[ Edit: 2012/ 5/ 18 Model: S35-D ]
prompts you for a name again.
Making a call by entering a phone
number
1. Push the button on steering wheel. A
tone will sound.
2. Say: “Call” *
A . The system acknowledges
the command and announces the next set of
available commands.
3. Say: “Phone Number” *
B . The system
acknowledges the command and an-
nounces the next set of available commands.
Say: “Special Number” to dial more than 10
digits or any special characters.
4. Say the number you wish to call starting with
the area code in single digit format. If the
system has trouble recognizing the correct
phone number, try entering the number in
the following groups: 3-digit area code, 3-
digit prefix and the last 4-digits. For example,
555-121-3354 can be said as “five five five”
as the 1st group, then “one two one” as the
2nd group, and “three three five four” as the
3rd group. For dialing more than 10 digits or
any special characters, say “Special Num-
ber”. See “How to say numbers” earlier in
this section, for more information.
5. When you have finished speaking the phone
number, the system repeats it back and
announces the available commands.
6. Say: “Dial” *
C . The system acknowledges
the command and makes the call.
For additional command options, see “List of
voice commands” later in this section.
Receiving a call
When you hear the ring tone, push the
button on the steering wheel.
Once the call has ended, push the button
on the steering wheel.
NOTE:
If you do not wish to take the call when you
hear the ring tone, push the
button on
the steering wheel to reject the call.
LIST OF VOICE COMMANDS
When you push and release the button on
the steering wheel, you can choose from the
commands on the Main Menu. The following
pages describe these commands and the
commands in each sub-menu.
Remember to wait for the tone before
speaking.
You can say “Help” to hear the list of commands
currently available anytime the system is waiting
for a response.
A menu item can also be selected by scrolling
the display with the SEEK switch and entering
by pushing the
button.
If you want to end an action without completing
it, you can say “Cancel” or “Quit” at anytime the
system is waiting for a response. The system will
end the VR session. Whenever the VR session
is cancelled, a double beep is played to indicate
you have exited the system.
If you want to go back to the previous command,
you can say “Go back” or “Correction” anytime
Center display, heater, air conditioner, audio, phone and voice recognition systems 4-75