Caution – NISSAN 2013 Rogue - Owner's Manual User Manual

Page 302

Advertising
background image

Black plate (300,1)

[ Edit: 2012/ 5/ 18 Model: S35-D ]

8-10

Maintenance and do-it-yourself

JVM0153X

Engine oil and filter

1. Place a large drain pan under the drain plug

*

A

.

2. Remove the oil filler cap

*

B

.

3. Remove the drain plug with a wrench and

completely drain the oil.

CAUTION

Be careful not to burn yourself, as the
engine oil is hot.

.

Waste oil must be disposed of

properly.

.

Check your local regulations.

Perform steps 4 to 9 when the engine oil
filter change is needed.

4. Remove the plastic cover over the oil filter

location by removing the small plastic clips.

5. Loosen the oil filter

*

C

with an oil filter

wrench. Remove the oil filter by turning it by
hand.

6. Wipe the engine oil filter mounting surface

with a clean rag.

CAUTION

Be sure to remove any old gasket
material remaining on the mounting
surface of the engine. Failure to do so
could lead to engine damage.

7. Coat the gasket on the new filter with clean

engine oil.

8. Screw in the oil filter clockwise until a slight

resistance is felt, then tighten additionally
more than 2/3 turn.
Oil filter tightening torque:

11 to 15 ft-lb
(14.7 to 20.5 N·m)

9. Install the plastic cover.

10. Clean and re-install the drain plug with a

new washer. Securely tighten the drain plug
with a wrench.
Drain plug tightening torque:

22 to 29 ft-lb
(29 to 39 N·m)

Do not use excessive force.

11. Refill engine with recommended oil through

the oil filler opening, and install the oil filler
cap securely.

See “Capacities and recommended fuel/
lubricants” in the “9. Technical and con-
sumer information” section for drain and refill
capacity. The drain and refill capacity
depends on the oil temperature and drain
time. Use these specifications for reference
only. Always use the dipstick to determine
the proper amount of oil in the engine.

12. Start the engine and check for leakage

around the drain plug and the oil filter.
Correct as required.

13. Turn the engine off and wait more than 10

minutes. Check the oil level with the dipstick.
Add engine oil if necessary.

Advertising
This manual is related to the following products: