NISSAN 2013 Rogue - Owner's Manual - Manual (Page 345)

Black plate (343,1)
[ Edit: 2012/ 5/ 18 Model: S35-D ]
STI0599
Use the following steps to mount the license
plate:
Before mounting the license plate, confirm that
the following parts are enclosed in the plastic
bag.
. License plate bracket
. J-nut 6 2
. Screw 6 2
. Screw grommet 6 2
1. Temporarily place the license plate bracket
by aligning the lower part *
A of it with the
lines *
B on the bumper.
2. Mark the pilot hole points with a felt-tip pen
through the holes of the license plate
bracket.
3. Remove the license plate bracket.
4. Carefully drill two pilot holes using a 0.39 in
(10 mm) drill bit at the marked locations. (Be
sure that the drill only goes through the
fascia, or damage to the nut may
occur.)
5. Insert grommets into the hole on the fascia.
6. Insert a flat-blade screwdriver into the
grommet hole to add 908 turn onto the part
*
C .
7. Insert a J-nut into the license plate bracket
before placing the license plate bracket on
Technical and consumer information 9-11
INSTALLING FRONT LICENSE PLATE