Warning – NISSAN 2013 Rogue - Owner's Manual User Manual

Page 274

Advertising
background image

Black plate (272,1)

[ Edit: 2012/ 5/ 18 Model: S35-D ]

6-8

In case of emergency

SCE0039

Installing the spare tire

The spare tire is designed for emergency
use. (See specific instructions under the
heading “Wheels and tires” in the “8.
Maintenance and do-it-yourself” section.)

1. Clean any mud or dirt from the surface

between the wheel and hub.

2. Carefully put the spare tire on and tighten

the wheel nuts finger tight. Check that all the
wheel nuts contact the wheel surface
horizontally.

3. With the wheel nut wrench, tighten wheel

nuts alternately and evenly in the sequence
as illustrated (

*

1

,

*

2

,

*

3

,

*

4

,

*

5

), more

than 2 times, until they are tight.

4. Lower the vehicle slowly until the tire

touches the ground. Then, with the wheel
nut wrench, tighten the wheel nuts securely
in the sequence as illustrated. Lower the
vehicle completely.

WARNING

.

Incorrect wheel nuts or improperly
tightened wheel nuts can cause the
wheel to become loose or come off.
This could cause an accident.

.

Do not use oil or grease on the
wheel studs or nuts. This could
cause the nuts to become loose.

.

Retighten the wheel nuts when the
vehicle has been driven for 600
miles (1,000 km) (also in cases of a
flat tire, etc.).

.

As soon as possible, tighten the

wheel nuts to the specified torque
with a torque wrench.

Wheel nut tightening torque:

80 ft-lb (108 N·m)

The wheel nuts must be kept tightened
to specification at all times. It is

recommended that wheel nuts be tigh-
tened to specifications at each lubrica-
tion interval.

.

Adjust tire pressure to the COLD

pressure.

COLD pressure:

After the vehicle has been parked for
three hours or more or driven less than
1 mile (1.6 km).

COLD tire pressures are shown on the
Tire and Loading Information label
affixed to the driver side center pillar.

Stowing the damaged tire and the tools

1. Securely store the damaged tire, jack and

tools in the storage area.

2. Replace the luggage floor box.

3. Replace the lids on the luggage side boxes.

4. Close the luggage floor board.

5. Replace the cargo cover (if so equipped).

6. Close the lift gate.

WARNING

.

Always make sure that the spare tire
and jacking equipment are properly
secured after use. Such items can

Advertising
This manual is related to the following products: