NISSAN 2013 Rogue - Owner's Manual - Manual (Page 325)

Black plate (323,1)
[ Edit: 2012/ 5/ 18 Model: S35-D ]
hours, or driven less than 1 mile (1.6
km) at moderate speeds. The recom-
mended cold tire inflation is set by the
manufacturer to provide the best
balance of tire wear, vehicle handling,
driveability, tire noise, etc., up to the
vehicle’s GVWR.
*
5 Tire size — see “Tire labeling” later in
this section.
*
6 Spare tire size or compact spare tire
size (if so equipped)
SDI1949
Checking the tire pressure
1. Remove the valve stem cap from the
tire.
2. Press the pressure gauge squarely onto
the valve stem. Do not press too hard or
force the valve stem sideways, or air will
escape. If the hissing sound of air
escaping from the tire is heard while
checking the pressure, reposition the
gauge to eliminate this leakage.
3. Remove the gauge.
4. Read the tire pressure on the gauge
stem and compare it to the specifica-
tion shown on the Tire and Loading
Information label.
5. Add air to the tire as needed. If too
much air is added, press the core of the
valve stem briefly with the tip of the
gauge stem to release pressure. Re-
check the pressure and add or release
air as needed.
6. Install the valve stem cap.
7. Check the pressure of all other tires,
including the spare.
SIZE
COLD TIRE
INFLATION
PRESSURE
FRONT
ORIGINAL
TIRE
P215/70-
R16 99H 230 kPa,
33 PSI
P225/60-
R17 98H 230 kPa,
33 PSI
P225/55-
R18 97V
230 kPa,
33 PSI*1
260 kPa,
38 PSI*2
Maintenance and do-it-yourself 8-33