Gamo P-25 Blowback Tactical - Manual (Page 24)

1.) selectINg the correct raIl MouNt for your pIstol
The Flashlight attaches to either a 3/8” grooved receiver or to a 5/8" “weaver-style” base. The laser is shipped with
the mounting rails for a “weaver-style” mount already installed. If you need to attach this device to a 3/8" grooved
receiver, you will need to loosen the rail screw and rotate the 5/8" weaver rail so the the 3/8" is visable.
2.) attachINg the correct MouNt to the devIce
Simply slide the appropriate rail onto your gun and tighten it into place utilizing the rail attaching screw. Note the
“weaver-style” rail utilizes a lock screw to prevent its slippage under recoil. This lock screw should be fit into the
groove found on most “weaver-style” mounts.
3.) actIvatINg the flashlIght
DO NOT LOOK DIRECTLY INTO THE FLASHLIGHT BEAM OUTPUT APERTURE DURING OPERATION. PERMANENT
EYE DAMAGE MAY RESULT.
3a.) Installing the batteries
Your new flashlight is powered by (1) one CR123 battery. Rotate push button counter clockwise to remove. Insert batter
(+) end facing out. Install push button switch by rotating clockwise until tight.
3b.) Main on-off switch
With this switch, you may turn the laser on or off.
DANGER !
WARNING !
CAUTION !