Gamo P-25 Blowback Tactical - Manual (Page 28)

3c.) Momentary pressure switch
This switch allows you to turn the unit on or off with pressure. The pressure switch access panel at the rear of the
device must first be opened. Open this panel by applying pressure on its top and rotating it down. Push the pin con-
nector on the end of the pressure switch firmly into the port. The pressure pad has an adhesive on its end and may be
attached to a convenient location on your pistol.
3d.) emission Indicator
Your laser is equipped with an emission indicator at the end that the laser projects from. The indicator glows red when
the laser is functioning.
4.) alIgNINg the laser wIth the path of the pellet
DO NOT LOOK DIRECTLY INTO THE LASER BEAM OUTPUT APERTURE DURING OPERATION. PERMANENT EYE
DAMAGE MAY RESULT.
eXercIse safe guN haNdlINg. shoot oNly at aN approved guN raNge or suItable locatIoN. use
eye aNd ear protectIoN as Necessary.
4A.) Activate the laser by either the pressure switch or the main switch.
4B.) Carefully fire (3) three shots.
4C.) Observe the bullet’s strike on the target. To move the point of impact, there are two screw ports at the front of the
device. The one marked “E” will move the point of impact up and down (Elevation) and the one marked “W” will move
the point of impact left and right (Windage).
BE CERTAIN THAT YOUR GUN IS UNLOADED AND POINTING IN A SAFE DIRECTION.
DANGER !
WARNING !
CAUTION ! DANGER !
WARNING !
CAUTION !
DANGER !
WARNING !
CAUTION !