Gamo P-25 Blowback Tactical - Manual (Page 27)

1.) selectINg the correct raIl MouNt for your pIstol
The laser attaches to either a 3/8" grooved receiver or to a 5/8" “weaver-style” base. The laser is shipped with the
mounting rails for a “weaver-style” mount already installed. If you need to attach this device to a 3/8" grooved receiver,
you will need to loosen the rail screw and rotate the 5/8" weaver mounting rail so the 3/8" is visible.
2.) attachINg the correct MouNt to the devIce
BE CERTAIN THAT YOUR PISTOL IS UNLOADED AND POINTING IN A SAFE DIRECTION.
Simply slide the appropriate rail onto your gun and tighten it into place utilizing the rail attaching screw. Note the
“weaver-style” rail utilizes a lock screw to prevent its slippage under recoil. This lock screw should be fit into the
groove found on most “weaver-style” mounts.
3.) actIvatINg the laser
DO NOT LOOK DIRECTLY INTO THE LASER BEAM OUTPUT APERTURE DURING OPERATION. PERMANENT EYE
DAMAGE MAY RESULT.
3a.) Installing the batteries
Your new laser is powered by (3) three long-life lithium batteries.Rotate push button counter clockwise to remove.
Insert batter (+) end facing out. Install push button switch by rotating clockwise until tight.
3b.) Main on-off switch
With this switch, you may turn the laser on or off.
DANGER !
WARNING !
CAUTION !
DANGER !
WARNING !
CAUTION !