Hudson Robotics Bar Code Print and Apply User Manual
Page 13
Print and Apply User Manual
Hudson Robotics, Inc.
11
3. Once the media and print ribbon are installed, slide the edge of the
media backing between the air blast and strip bar. Once it is exposed
below the air blast, pull enough media through so it is long enough to
fit around the lower spindle. Tape the media to the lower spindle.
4. Once the media and ribbon are secured to the spindles, the print head
can be lowered back into position and closed. After the print head is
closed, the unit will be in a paused mode. To un-pause the printer,
simply press the pause button. Once the unit is un-paused, or powered
up, it will perform a short calibration requiring a feed of multiple
labels. Remove the built up labels from the air blast before running the
unit.
Pause Button
Build up after
calibration