Hudson Robotics Bar Code Print and Apply - Manual (Page 30)

Print and Apply User Manual Hudson Robotics, Inc.
28
CHAPTER 5 - Maintenance
A. Maintenance
WARNING- -

Qualified personnel can perform all maintenance procedures in this
manual. Only Hudson representatives should perform any maintenance
not discussed in this manual.

Gloves should be worn during any cleaning procedure.
B. Cleaning the Print and Apply

Note: DO NOT use/spray abrasive cleaners onto Print and Apply
applicator.
 Clean the outside surfaces of applicator using cloth or sponge dampened with
alcohol or mild glass cleaner.
 Clean Applicator head with alcohol or other residue-free solvent.
 Clean any spills on Print and Apply immediately.
 Only clean the exterior of the unit. DO NOT remove instrument covers to clean
inside.
 Never allow water or fluid to leak inside the Print and Apply.
C. Cleaning the Printer

Note: DO NOT use/spray abrasive cleaners onto the Printer.
The printer must be cleaned every time the media is replaced or when
you are having issues printing correctly. You will need to clean the two
white rubber rollers and the print head that are inside the printer. After
cleaning the printer, allow the system to Print and Apply 25 labels to
allow the printer to self-align the new media.