Hudson Robotics Bar Code Print and Apply - Manual (Page 5)

Print and Apply User Manual Hudson Robotics, Inc.
3
CHAPTER 2 – Installation
A. Unpack the Print and Apply
WARNING- -

Power switch must be turned OFF during entire installation procedure.
DO NOT loosen or tighten any screws or touch parts not specified in the
instructions.
Never force any component to fit.
The Print and Apply system weighs

50 lbs. and should be handled with
care to avoid mishaps.
Overview:
The Print and Apply will arrive in three separate boxes. The Zebra box contains
the printer portion of the system. The Hudson box contains the applicator portion
of the system. The third box contains the alignment base for the printer which
connects the printer to the applicator. Any additional components will be packed
in the Hudson box along with the applicator.
Below are the following steps to unpack the system:
1. Open the third box and remove the alignment base from the box and place
it on the table that will hold the Print and Apply system.